How to Fill Water Tank

1. Remove case cover - pull on case knobs on both sides of cover and lift upwards.
2. Press Water Tank Release Button.
3. Remove Water Tank.
4. Open Water Fill Cover.
5. Fill to Full Water 満水 mark.
6. Close Water Fill Cover.
7. Reattach Water Tank (push until you hear a click).
8. Set Temperature Setting Knob to OFF 切.
   
9. Pull retractable AC Power cord and plug into outlet.
10. Set temperature - Low 低, Medium 中, High 高.
11. When Pilot Lamp goes off, iron is at desired temperature (when pilot lamp goes off during use, return to stand to reheat).

Steam/Dry Selector

1. Dry - press Steam/Dry Selector until you hear a click and selector is pressed.
2. Steam - press Steam/Dry Selector until selector released.

Steam Shot Button

1. Set temperature to High 高, at Low 低 or Medium 中, liquid may leak out or the shot may not be released.
2. Set Steam/Dry Selector to Dry.
3. Place iron over desired area of item, press and release Steam Shot Button.

After Use

1. Unplug and pull retractable AC Power Cord, release slowly.
2. Set Steam/Dry Selector to Dry.
3. Press Water Tank Release Button.
4. Remove Water Tank.
5. Empty Water Fill Cover.
6. Reattach Water Tank (push until you hear a click).
7. Replace case cover.